![]() |
View
New Forum Topics Today's Forum Topics Set as homepage |
|
|||||||
Welcome to CyclingForums.com You are currently viewing our website as a guest which gives you limited access to view most discussions. You will have to register before you can post to this thread. By joining our free online community you will have access to post new topics, communicate privately with other cyclingforums.com members (PM), respond to polls, upload photos and access other special features like product reviews and classifieds. |
|
|
|
Thread Tools | Search this Thread | Display Modes |
|
|
#1 |
|
Registered User
Join Date: Jun 2005
Posts: 198
|
I've been doing 4 min. intervals at 115% of my FT. I can complete 5 reps consistently. I don't know if I should be trying to extend the inteval length, decrease the recovery, or up the wattage. Or should I try for 6 reps? My goal is to increase FT and MAP. Forgive me if this has been asked before. I believe that completing 6 reps would put me over the equivalent stress rating of my 2x20 workout. Would that suggest an increase in FT?
|
|
|
|
|
|
#2 |
|
Registered User
Join Date: Dec 2003
Location: London, England
Posts: 269
|
i'd say up the wattage.
__________________
I am my favorite rider. |
|
|
|
|
|
#3 | |
|
Registered User
Join Date: Apr 2005
Location: Kansas City, USA
Posts: 3,689
|
Quote:
While it is possible that your FT power has gone up, doing a workout where the TSS score is greater than a 2x20min workout does not necessarily indicate an increase in FT. I'd say you should do a test to see if your FT power has gone up, and do another rep of your 4 minute intervals until then (as long as the added stress fits into your current stress/recovery routine). |
|
|
|
|
|
|
#4 | |
|
Registered User
Join Date: Nov 2003
Posts: 577
|
Quote:
When I do 5x5:00 or 6x5:00 I usually target 115%FT. 115% is probably too low (for me anyway) for 4min intervals. To improve your FT, focus on FT intervals (do mix it up with 4 & 5 min intervals though). |
|
|
|
|
|
|
#5 | |
|
Registered User
Join Date: Aug 2004
Location: Oakland, California
Posts: 266
|
Quote:
__________________
Smartty |
|
|
|
|
|
|
#6 | |
|
Registered User
Join Date: Jun 2005
Posts: 198
|
Quote:
Yeah, it's probably a good idea to re-test at this point. I think I've slightly over-estimated my FT since I'm basing the 115% on my 20 min. power, rather than my 1 hour output. Unless it's the same? At any rate, there must be benefits to doing 4 min. intervals at 115% or 120%, or whatever it turns out to be. Do you suggest a 1 hr. time trial? |
|
|
|
|
|
|
#7 | |
|
Registered User
Join Date: Jun 2005
Posts: 198
|
Quote:
Also, just to clarify, what does MAP correspond to in terms of actual cycling performance? IS it an effort that can be sustained for 4-6 min? |
|
|
|
|
|
|
#8 | |
|
Registered User
Join Date: Aug 2004
Location: Oakland, California
Posts: 266
|
Quote:
In terms of cycling performance, your MAP is the basis from which all your aerobic performance abilities stem from; that is, your FT and LT are based on your MAP, not the other way around. One can have a higher FT/LT as a % of MAP (which correlates very highly with increased cycling performance), but you have to have a high MAP in order to have high FT because FT can only be raised so high in relation to your MAP. The time frame for a single effort relating to MAP depends on the protocol used to establish your MAP; it could be anywhere from 3-6min.
__________________
Smartty |
|
|
|
|
|
|
#9 | |
|
Registered User
Join Date: Apr 2005
Location: Kansas City, USA
Posts: 3,689
|
Quote:
Regarding the 1 hr TT, it depends on whose zones you're using. Each training scheme is based on it's own measurement protocol (40K TT for Coggan, 25W/minute ramping MAP test for Stern, etc.). You should re-test using the protocol which matches the zones you are using. |
|
|
|
|
|
|
#10 | |
|
Registered User
Join Date: May 2005
Location: Las Vegas, NV
Posts: 4,115
|
Quote:
|
|
|
|
|
|
|
#11 |
|
Registered User
Join Date: Apr 2005
Location: Kansas City, USA
Posts: 3,689
|
Sure, but the original question stemmed from the feeling that his current 115% FT interval set had gotten too easy. He asked whether he should do more reps or bump up the intensity. Before someone does either of those two options, I would suggest a check to see if either one is really necessary. In other words, maybe correcting your FT value would put the original interval set back to a challenging level without modifying the workout structure. If your FT has changed and you don't worry about it then you're really training by feel, or at best training BY power and selecting arbitrary wattages for your interval sets.
Seeing those bumps in FT power has got to be the best intermediate reward for your training program, right? |
|
|
|
|
|
#12 | |
|
Registered User
Join Date: May 2005
Location: Las Vegas, NV
Posts: 4,115
|
Quote:
|
|
|
|
|
|
|
#13 |
|
Registered User
Join Date: Apr 2005
Location: Kansas City, USA
Posts: 3,689
|
I agree that 1 hr TT's aren't anything to look forward to, and I haven't done one yet either for that same reason. As an alternative, one can track their output over long intervals (ie, 20-30 minutes) as well to catch the changes in FT, and that's something that can be observed during a typical workout.
I still think there's a motivational advantage to noticing "Cool! 2% rise in FT power!" As opposed to "These seem kinda easy, I guess I'll push a little harder next time." |
|
|
|
|
|
#14 | |
|
Registered User
Join Date: May 2005
Location: Las Vegas, NV
Posts: 4,115
|
Quote:
|
|
|
|
|
|
|
#15 | |
|
Registered User
Join Date: May 2005
Location: Las Vegas, NV
Posts: 4,115
|
Quote:
|
|
|
|
|