Separate names with a comma.
Just a thought on this bike. While it may by the angle of the picutre, it appears the fork is bent, probably from a head on impact. Draw an...
The torque is only a recommendation. The concept is to bring the arm over to the bearing, but no more. After securing the pinch bolts, push on...
See also http://www.parktool.com/repair/readhowto.asp?id=85
It is unkiley the bearings are shot after only a few hundred miles. Most "clicks" are the result of something being loose. Try to isolate the...
It is certainly not uncommon. Aluminum is of course softer then steel, but that is one of the trade offs to save weight. To minimize this type...
For more on headset service, see http://www.parktool.com/repair/readhowto.asp?id=127
Having the original frame spec's will of course be useful. It is also useful to keep track of how you set the bike up, that is, with saddle...
The Campagnolo B-screw is on the lower pivot. The upper pivot spring is fixed. The two springs oppose each. Loosen the B-screw here to move the...
For an overview of headset types see http://www.parktool.com/repair_help/howfix_headtypes.shtml
It is likely the bike is 126mm wide, and you will be going only up to 130mm, which is 2mm per side. It is very likely this can be done well by a...
Possibly there is no agreement on what is a "flange". The image below show what I was considering a flange on the Ultegra non-drive cup....
The Ultegra non-drive cup has a flange, or lip, with eight-notches. This "cup", or adaptor ring as Shimano calls it, presses against the bottom...
It is possible the front chainwheels are too far from the bike center line. As the chain wears and rounds the teeth, the noise should quite down...
It is difficult to re-use some brands of tape. It is not a very difficult process. See for the procedure:...
It can take several hours for the Loctite to fully cure. Proceed with the rest of the work. The Service Removeable #242 should be adequate. For...
It will eventually be important to ride and use trial-and-error to dial in the best posture and position. To help track how you are positioned on...
If the steering column is carbon or aluminum, it should not be threaded. However, if the column is steel and has the correct sizing, it can be...
I think you are asking about handlebars, not a headset. Is that correct? See http://www.itm.it/ for instructions.
There are certainly different ideas and systems for fitting the person to the machine. It can be useful to get advise and help, but at some...
