Separate names with a comma.
Anybody know of a two person multiday road race in the USA? Not a relay, two riders riding each stage. Say 5-7 days or so. BC Bike race...
I suggest you review your finances and try to swing for a CT.There is nothing nicer than writing an .erg file for LTs or VO2 intervals and then...
If I recall correctly, the early wired yellow kit user manual had a DOS c prompt command whereby one could upload to a computer. Anybody recall...
As a paying client I hope to ride this: http://bike-alive.com/#/sirocco/4544434375. Like any organized and well run event, it needs a minimum...
All went well. Turns out it was bilateral - one on each side. Doctor suggested one week off the bike, then riding only on a trainer for a week....
I appreciate the replies done with sincerity. Though doctors have a lot of training, and I think I have picked a good one, each patients's healing...
I'll let you know after the job is done. What have others experienced??
I go in for laparoscopic mesh repair soon. How long has it taken others to get back riding??
Why is there so much discepancy between the vertical feet reported by: Garmins Polar units mapmyride DeLorme etc., What is the most accurate...
Found an article that talks of the "physiological impact", and answers my question. Intensity Factor and Training Stress Score | Two Wheel Blogs
Is my general rule of thumb correct (for a cyclist): Frontal & surface friction increase by the square when velocity doubles. Power requirements...
Where do you all consider the finish line to be?? Just before the pedestrian bridge, at the end of the first, short string of shops>
Is there a real world situation when one experiences negative trail? Say when one is mountain biking, or doing trials, or trick bmx?
You are correct. My mental (visual) block. Thaks for explaining it so nicely.
No, I don't think so. The contact patch moves as does the intersection.
It seems to me the trail is the same in all three scenarios - axles aligned, wheel in front, wheel in back. As the axles(plumb line) moves, so too...
Why not? Most rollers are set up this way. The original question is more a thought experiment. Just idle chatter at the LBS.
Becasue it is a pain in the ass to change the roller wheel position. Assume neutral weight distribution.
A misc question on physics and dynamics, just downtime chatter at our LBS: Which is more (or less) stable, the front axle (skewer) slightly...
I have 2 wired and 2 wireless. Oldest is about 5 years. No unusual problems. Cross bike and mtb clip trees, shrub, etc. so I have gone through...
