Hi there,
I have a Diamondback Insight 1 2009 model. I'm trying to attach both a fender and a rack to it, but can't seem to quite figure out where to attach it. Attaching the front fender was no problem, but with the rear there appears to be no proper hole on the gear side. There are 2 holes on the other non-gear side that look perfect, but the only hole on the gear side seems too close to the gears and doesn't line up with either of the 2 holes on the other side.
I've attached some pictures below. Has anyone else had this issue? Are there any possible solutions? (Attachment? Drilling into the frame?)
Thanks!
Derrick
I have a Diamondback Insight 1 2009 model. I'm trying to attach both a fender and a rack to it, but can't seem to quite figure out where to attach it. Attaching the front fender was no problem, but with the rear there appears to be no proper hole on the gear side. There are 2 holes on the other non-gear side that look perfect, but the only hole on the gear side seems too close to the gears and doesn't line up with either of the 2 holes on the other side.
I've attached some pictures below. Has anyone else had this issue? Are there any possible solutions? (Attachment? Drilling into the frame?)
Thanks!
Derrick