I installed my ergomo last night and all went well until I tried the front derailleur. I could not adjust it to go into the big ring without great difficulty (pushing and holding the shift lever- Shimano). I had a spacer from an XT external bottom bracket crankset (about 3-4mm thick) so I put it on the non drive side of the ergomo to effectively shorten the spindle length on the drive side. It worked and now I can shift easily. The wires come out at 10:00 now right along the downtube, I may put another of the ergomo spacers in to try to get it to 9:00. Does anyone see a problem with using a thicker spacer? I am going to call the shop where I bought it and ask if it is available in a shorter spindle length.