S
Simon Fisher
Guest
One of my girlfriend's bikes has Campag Record ErgoPower Levers. The bike
was custom built new in 2002 so I guess the levers are of that year.
The left lever operates the front mech over a triple chainring set. It's
suddenly developed a fault whereby it fails to hold the mech over the
larger/outer rings. It seems as if something in the lever has failed as
pulling the gear cable away from downtube to create tension in the wire
causes the inards of the lever to move (slip) rather than moving the mech.
I haven't done any further investigation of the lever yet. Can anyone
comment as to whether this is likely to be a fault that I can repair - are
spares likely to be available? Or is it the case that a new lever will be
required?
was custom built new in 2002 so I guess the levers are of that year.
The left lever operates the front mech over a triple chainring set. It's
suddenly developed a fault whereby it fails to hold the mech over the
larger/outer rings. It seems as if something in the lever has failed as
pulling the gear cable away from downtube to create tension in the wire
causes the inards of the lever to move (slip) rather than moving the mech.
I haven't done any further investigation of the lever yet. Can anyone
comment as to whether this is likely to be a fault that I can repair - are
spares likely to be available? Or is it the case that a new lever will be
required?