Cycling Equipment · Public discussion

Installing a Travel Agent for v-brake

Started by clumsymechanic · · Last activity · 3 posts · 400 views

Thread details

What we know about this thread

Original section
Cycling Equipment
Published
4 September 2006
Last activity
6 September 2006
Original author
clumsymechanic
Posts
3
Discussion status
Public discussion
Total views
400
Views / 30 days
0

The navigation and discussion metadata provide context. Posts remain in their original chronological order.

Showing posts 1–3 of 3
Posts remain in their original chronological order.

Text size
  1. I bought some generic Travel Agent type clones at the LBS, and they
    didn't come with instructions. Having a hard time getting them
    installed:

    So the cable goes in the inner hole on the top, loops around the
    smaller pully, transitions to the edge of the larger concentric pulley,
    then loops around again and exits the travel agent.

    I found a photo of the avid one installed on a bike, it looks like 180
    degrees of cable engage the smaller pulley, (
    http://www.performancebike.com/shop/profile.cfm?SKU=2647#
    ), which is how I've set mine up. The problem I'm having is the
    transition between pulleys.

    Do you need to pre-bend the cable to get it to seat right in this
    thing? I keep getting a big protruding kink, and the cable not seating
    nicely on either side. The friction is terrible.

    Thanks for any tips,

    Adam

  2. clumsymechanic said:

    I bought some generic Travel Agent type clones ...The problem I'm having is the
    transition between pulleys...Do you need to pre-bend the cable .. I keep getting a big protruding kink,

    Drawing from the HUGE, near unlimited experience of having installed two of these I think a bit of assisted settling is in order. I don't know if I'd call it pre-bending, as it has to be done with everything assembled in order to get the bend in place. Use moderate force (push with your fingers, piece of wood etc..) to get the kink to settle.

  3. dabac said:
    clumsymechanic said:

    I bought some generic Travel Agent type clones ...The problem I'm having
    is the
    transition between pulleys...Do you need to pre-bend the cable .. I
    keep getting a big protruding kink,

    Drawing from the HUGE, near unlimited experience of having installed
    two of these I think a bit of assisted settling is in order. I don't
    know if I'd call it pre-bending, as it has to be done with everything
    assembled in order to get the bend in place. Use moderate force (push
    with your fingers, piece of wood etc..) to get the kink to settle.

    My experience is about the same... I've installed a couple, and I also
    had to kink the cable a bit after installation.

    --
    Dave
    dvt at psu dot edu

    Everyone confesses that exertion which brings out all the powers of body
    and mind is the best thing for us; but most people do all they can to
    get rid of it, and as a general rule nobody does much more than
    circumstances drive them to do. -Harriet Beecher Stowe, abolitionist and
    novelist (1811-1896)

Active in the last 60 minutes

Active in this thread

0 users · 0 guests ·0 bots ·0 total

No signed-in users are active right now.

No known search crawlers active right now.