Low Priced Bike Parts

  • Thread starter Donald R ORourke
  • Start date


Donald R ORourke

Low Priced Bike Parts

Maillard aluminum front quick release hub laced with 36 plated spokes to a
27 inch Rigida steel wheel
The chrome plating is not perfest but it is surprisingly good $10 plus $10

Fuji gray frame fork and headset. 56 cm or 22 inch c to c seat tube 58 cm or
23 inch top tube
$20 UPS shipping is $30

SR Aluminum 170mm left crankarm that fits all older Jap, Korean and
Taiwanese square tapered bottom
brackets.With retaining bolt. $7

Dia Compe center pull brake short reach. 54 to 70mm distance from the
mounting bolt to the shoe
slot. complete with cables triangular cable mount and quick release fittings
to mount on the seat
post bolt $5 one only

Vetta Gel Flex mans black smooth cover saddle. It is 7 inches wide,10 inches
long.Soft thick gel
foam over a flexible base.New Old Stock $5

SR Aluminum 26.8 seatpost with no integrated clamp $5 includes the separate
steel sadddle clamp
Click below for a picture:


Fuji Maeda Ind Japan short open cage rear derailler that comes with a
removable tab to mount under
the rear Axle nuts.if you remove the tab the derailler will mount on the tab
on the frame $5

Shimano freehub spoke protectors one is for 36 spokes and 34 teeth, another
is for 32 spokes and 32
teeth $2 each

Front Deraillers-large offset inner plate in the cage.clamps to a 1 1/8
seatpost,bottom pull,.
Made in China $3-SR spirit that clamps to a 1 1/8 seatpost,bottom pull. It
has a reverse action so that the
shift levers move the same way to shift up or down. Poor cosmetically $3

Front Forks
RD Fibre one inch threaded fork with aluminum stem and dropouts. The stem
is 7 1/8 inch long with
threads starting at 5 3/4 inches for a 55 to 58 cm frame $35

Stronglight One inch threaded headset Silver with aluminum cups and roller
bearings $15

Early model made in Chicago Schwinn.Refinished in White.The steerer tube is
6 and 3/4" high threaded
to 5 and 5/8 inches high.The legs are thinner than most,they measure 25 mm
wide near the top but
only 10 mm thick.Headset included.

Standard one inch steerer blue with scratches.The steerer is 132 mm or 5
inches high, threaded to
100 mm or 3 and 7/8 inches.There are unthreaded fender eyelets. The legs are
25.5 mm or one inch
wide near the top and 18 mm or 3/4 inch thick. there is a box crown with a
chrome plated cover.This
will fit almost all small frames. Headset included.

Huffy Mtn Bike one inch Forks $5 each complete with a full headset.one for
26 inch wheels is
red, the 24 inch wheel fork is black. these require brakes that mount on a
single central hole
in the crown.$5 each

Black resin Mtn Bike brake front lever with orange inner and outer cables $3

front shfter that clamps on the handlebar with orange inner and outer cables

6 speed index shifters that clamp on the handlebar with black outer cables.
A rear inner cable is
included $5

130 mm bolt on 36 spoke rear hub with 36 spokes and nipples to lace up a 26
inch Mtn bike rim which
is not included $5

SR 52 tooth aluminum chainring to fit a 120 mm 5 hole bolt pattern
originated by Stronglight for
their 99 and 100 cranks and also used by SR.This bolt pattern measures 70 mm
from the center of one
of the 5 bolt holes to the center of the next bolt hole.If yours measures
the same it will fit.This
pattern was used for both doubles and triples.A triple will mount 3 rings on
the same bolt pattern
that permits a 28 tooth small chainring.It is nearly new with an aluminum
overide ring to keep the
chain from overshifting the big ring and also to keep your pant cuff out of
the chain. $3

Stems and Handlebars

Aluminum clamp on handlear extensions $10

Profile Aluminum clamp on lay down bars with armrests $25

Profile Aluminum threaded Road Stem 120 mm for a one inch stem Removable 2
bolt handlebar clamp 26 mm $10

SR aluminum Road Stem short 50 mm reach for handlebars with a one inch or
25.4 diameter the stem diameter is the
english standard .222 It is longer than usual at 19 cm
Similar Nitto Youth 80 MM reach i6 cm length $5 each

Tioga Prestige butted steel black Mtn Bike threaded one inch 135 mm $5

two steel 10 speed handlebars and steel stems. The chrome plating is still
good. One bar is 13"wide
edge to edge 5"reach c to c and 5 1/2"drop c to c. The other is 16 1/2-5
1/2-5 3/4. Both stems have
a reach of 2 1/4" and a stem diameter of about 20mm. Either bar and stem is
$15 plus $7 shipping.

Nitto B115 420 aluminum 10 speed handlebar with one inch or 25.4 mm
clamping area $15

Fuji Nitto Olympeade Steel 10 speed Handlebar 15 1/2"c to c 4 1/2" reach
6"drop. only a lttle rust $5

Steel Mtn Bike handlebars,one is flat black with a 6 degree pullback,another
is black 23"wide with a
6 degee pullback,the last is 23"wide gray with an 8 degree pullback. $5 each

priority mail is $4.50 additional on most items.Pay Pal OK.
Phone 732 566 2865 Aberdeen NJ Paypal name DonaldORourke Pay Pal fee is 2.9%
plus .30
cents more https://secure.paypal.com/affil/pal...40optonline.net