Park FAG-2 frame alignment checker owners..

Discussion in 'Cycling Equipment' started by Ant, May 15, 2003.

Thread Status:
Not open for further replies.
  1. Ant

    Ant Guest

    I want to make one. I'm hoping someone will take three quick and dirty measurements for me, as I
    cant find one around here to measure myself, and it would save me running around measuring all sorts
    of bicycles to make sure my own tool worked as necessary-

    my questions:
    1. how long is the straight edge that rests across ST/HT, before the tool bends
    2. when you place the straight edge on the ground, how high is the curved part above the ground?
    3. about how long is the tool altogether?

    nothing terribly accurate necessary. i just need to get in the ballpark, i think

    thanks! anthony

  2. Ant-<< I want to make one.

    Have some string? You already have one. Tie onto one dropout, loop around headtube, tie to other.
    measure distance from string to seattube on each side-ya got a 'FAG' tool...

    Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302
    (303)440-3535 "Ruote convenzionali costruite eccezionalmente bene"
Thread Status:
Not open for further replies.