Polar CS200 RESET

starship said:

I am tring to setup a new CS200CAD, and the software says to reset after uploading the ODO data.

How do you do a reset?

To reset the CS200:
1. press all three buttons at the same time till all characters are displayed.
2. immediately and quickly press the left and right button separately one after the other.
3. you will some display of characters, then press the right button continuously until reset to default shows
4. press middle button and your done.

Also, if your CS200 serial number is X55...or higher then you have the later software revision unit. There were some CS200's that still have lower numbers with newer software revisions but not many. There is no way to tell if you have a later revision unless it is sent to the factory.

jberenyi said:

Also, if your CS200 serial number is X55...or higher then you have the later software revision unit. There were some CS200's that still have lower numbers with newer software revisions but not many. There is no way to tell if you have a later revision unless it is sent to the factory.

No way to tell? 🙄 Then whats the number at the bottom after the left/right sequence:p

impakt said:

No way to tell? 🙄 Then whats the number at the bottom after the left/right sequence:p

And DO NOT do a default reset if you are trying to update the ODO. This will clear out everything including that new setting. Just press all 3 buttons. Then the OK button and reenter time/date