powertap 2.4 problem

[bubba 02]

The display showed "lowbatt" on my 2.4sl ,so I replaced the battery with a brand new energizer battery and the only thing the comes up now is "apidc" at the bottom of the screen??? Ive tried to hold both mode and select at same time, it just diplays "apidc" or"rpidc" has anyone ran into this???

 

[giannip]

did you try taking the battery out and put back in again ?

 

[bubba 02]

did you try taking the battery out and put back in again ?

oh yes,several times, same thing comes up

 

[lookatmy595]

Same thing happened to me recently. Connect the unit to your pc and make sure its turned on,

saris.com - cyclops power - customer support - firmware updates

 

[packfill]

The display showed "lowbatt" on my 2.4sl ,so I replaced the battery with a brand new energizer battery and the only thing the comes up now is "apidc" at the bottom of the screen??? Ive tried to hold both mode and select at same time, it just diplays "apidc" or"rpidc" has anyone ran into this???

Agree with the advice here. I found the firmware update as critical to fix the issue....

Good luck. It drove me nuts until I started to straighten that out.