I'm a fat guy, about 230-240 pounds, and I bend non-splined cranks left
and right. Anything with a height of over about 3 feet seems to kill
the cranks. Unless they are aluminum doteks...then a 5 inch jump kills
them. I'll be ordering a profile set this week though, so no worries.
<threadjack>Its kind of good in a way. Due to the bent cranks, I have
learned a lot of freestyle on my other uni. So far, I've learned hop on
wheel (the kind where you hop seat out, jump of the pedals, spin the
uni, and land on the tire), uni-spin, rolling mount, rolling 1 foot
mount, a little bit of wheel walking, 1 foot ride (duh), side mount to
seat out ride, rolling seat out ride (which is really sketchy), and the
aerial. I've been unicycling since april 24th of this year. Ok, I'm
done bragging :p </threadjack>
Quoted message said:So when you bend the cranks does profile replace them for free for the
lifetime warranty?
I should hope they do...A fat kid like myself will probably be needing a
new set after a 5 or 6 foot drop.
--
digitalattrition - Rat Fink
Unicycling consists of the two Bs: balance and balls. Without these,
you cannot progress
------------------------------------------------------------------------
digitalattrition's Profile: http://www.unicyclist.com/profile/6430
View this thread: http://www.unicyclist.com/thread/31243