hi, i just installed a 8/9 speed freehub on my rearwheel which had a 6/7 speed freehub on it before.
i followed sheldon's advice on his page on shimano cassettes, but have 2 questions. with the new,
longer freehub, i only have about 3mm of axle sticking out of each end for the frame to sit on. i
know sheldon says this is no problem, but the guys at the workshop i was working were skeptical.
anybody have any experience with this? (axle length = 137mm, frame width, inside to inside = 130mm,
thus roughly 3.5 mm on either side to actually seat the frame.) secondly, i tried to dish the wheel
to recenter it, but it seemed to need 5mm or more pull to the cassette side, and the spokes there
are already tight and run almost straight from the hub to the rim. is it better to have the wheel
completely centered and have a very lopsided looking wheel, or to have the tire a bit off and have a
more even wheel? thanks for any advice--
v.
Cycling Equipment · Public discussion
rear axle size
Thread details
What we know about this thread
- Original section
- Cycling Equipment
- Published
- 25 June 2003
- Last activity
- 26 June 2003
- Original author
- Vincent Chiao
- Posts
- 3
- Discussion status
- Public discussion
- Total views
- 409
- Views / 30 days
- 0
- Topics
The navigation and discussion metadata provide context. Posts remain in their original chronological order.
-
-
vincent chiao said:
secondly, i tried to dish the wheel to recenter it, but it seemed to need 5mm or more pull to the
cassette side, and the spokes there are already tight and run almost straight from the hub to the
rim. is it better to have the wheel completely centered and have a very lopsided looking wheel, or
to have the tire a bit off and have a more even wheel? thanks for any advice--If the right side is already as tight as it will go, start by backing off the left a bit. Check (by
fliiping the wheel over left/right wise, without a cassette on) whether the wheel really needs that
much redishing first, or maybe it's just your frame that's crooked. The rim needs to be directly
between the axle locknuts, and then the bike needs to make sure that the rim ends up in the middle
of the bike.Jasper
-
vincent chiao said:
hi, i just installed a 8/9 speed freehub on my rearwheel which had a 6/7 speed freehub on it
before. i followed sheldon's advice on his page on shimano cassettes, but have 2 questions. with
the new, longer freehub, i only have about 3mm of axle sticking out of each end for the frame to
sit on. i know sheldon says this is no problem, but the guys at the workshop i was working were
skeptical.That is fine the way it is.
Quoted message said:
secondly, i tried to dish the wheel to recenter it, but it seemed to need 5mm or more pull to the
cassette side,yep
Quoted message said:
and the spokes there are already tight and run almost straight from the hub to the rim. is it
better to have the wheel completely centeredYes, the wheel needs to be centered for the bike to handle well. All of us have wheels with that
extreme a dish nowadays, and they do hold together -- if they are tight enough.--
David L. Johnson
__o | the people can always be brought to the bidding of the leaders. _`\(,_ | That is easy. All
you have to do is tell them they are being (_)/ (_) | attacked, and denounce the peacemakers for
lack of patriotism and exposing the country to danger. It works the same in any <country. --
Hermann Goering
Active in the last 60 minutes
Active in this thread
0 users · 0 guests ·0 bots ·0 total
No signed-in users are active right now.
No known search crawlers active right now.