Ok I'm new to this.
I just bought a new 2004 Trek Navigator 100 for myself, well the wife rode it and now wants a suspension seat post for her GT Outpost Trail, I found one that fits, but the problem is that it will not go down far enough, it stops where the seat post bolt is.
What I'm wanting to know is it possibe to cut about an inch off just below where the welds are for the seat post bolt holes and put a quick release seat post clamp on. I've done some measuremants and it looks close to a 28.6mm diameter.
http://www.nashbar.com/nashbar_photos/medium/NA-QRSC.gif
I just bought a new 2004 Trek Navigator 100 for myself, well the wife rode it and now wants a suspension seat post for her GT Outpost Trail, I found one that fits, but the problem is that it will not go down far enough, it stops where the seat post bolt is.
What I'm wanting to know is it possibe to cut about an inch off just below where the welds are for the seat post bolt holes and put a quick release seat post clamp on. I've done some measuremants and it looks close to a 28.6mm diameter.
http://www.nashbar.com/nashbar_photos/medium/NA-QRSC.gif