D
David Nutter
Guest
I've had a front wheel built with a NX-30 hub dynamo but I can't figure out where the switch is
supposed to go for sure. The best I can come up with is bolted to the fork crown through the hole
used for caliper brakes but this seems less than ideal as it interferes with mounting headlights and
mudguards.
The sensible place would be the handlebars but there isn't enough cable for that.
Since the switch isn't mentioned in the instructions for the dynamo, can anyone point me in the
right direction?
Regards,
-david
supposed to go for sure. The best I can come up with is bolted to the fork crown through the hole
used for caliper brakes but this seems less than ideal as it interferes with mounting headlights and
mudguards.
The sensible place would be the handlebars but there isn't enough cable for that.
Since the switch isn't mentioned in the instructions for the dynamo, can anyone point me in the
right direction?
Regards,
-david