Spinergy Rev X rear hub rebuild info needed.....

[Rob Benetton]

So what's the drill here?My drive side cone is shot.Some
people say this is a standard Shimano 105 part...After
pulling the cone,how do you get the axle out to replace the
left side sealed bearing?ANy help here greatly
appreciated!Thanks!

 

[Michael Press]

[email protected] (Rob Benetton) wrote:
>So what's the drill here?My drive side cone is shot.Some
>people say this is a standard Shimano 105 part...After
>pulling the cone,how do you get the axle out to replace the
>left side sealed bearing?ANy help here greatly
>appreciated!Thanks!

Check out spinergy.com. There's a tech section that has
exploded diagrams of their wheels. I used these to rebuild
my spox hubs, which used an XT cone. I think I also had to
push/punch out a doohickey on the other side using the axle
or similar tool.

Michael

 

[Rob Benetton]

[email protected] (Rob Benetton) wrote in message news:<[email protected]>...
> So what's the drill here?My drive side cone is shot.Some
> people say this is a standard Shimano 105 part...After
> pulling the cone,how do you get the axle out to replace
> the left side sealed bearing?ANy help here greatly
> appreciated!Thanks!
Anybody done this?