Spoke hole diameter of a Shimano HB-NX70 dynamo?

[Ian Yates]

Can somebody please post the hub dimensions of the Shimano HB-NX70 hub dynamo.

Spoke hole diameter? Width to left of centre? Width to right of centre? Left flange diameter? Right
flange diameter?

I need the dimensions so that I can spokes using Spocalc.xls.

Thanks Ian

 

[Alex Rodriguez]

In article <[email protected]>, [email protected] says...
>
>
>Can somebody please post the hub dimensions of the Shimano HB-NX70 hub dynamo.
>
>Spoke hole diameter? Width to left of centre? Width to right of centre? Left flange diameter? Right
>flange diameter?
>
>I need the dimensions so that I can spokes using Spocalc.xls.

If you have the hub, just measure it. It is not that hard to do.
------------------
Alex

 

[Ian Yates]

> If you have the hub, just measure it. It is not that hard to do.
Thanks for yor helpful comments.... I will measure the hub (once it arrives from the supplier).

Ian

 

[Marten Hoffmann]

[email protected] schreef ...
> Can somebody please post the hub dimensions of the Shimano HB-NX70 hub dynamo.
>
> Spoke hole diameter? Width to left of centre? Width to right of centre? Left flange diameter?
> Right flange diameter?
>
> I need the dimensions so that I can spokes using Spocalc.xls.

Very often, these hubs have overly wide spoke holes to make lacing them by machine easier. It's wise
to use small rings under the spoke heads to make them fit snugly.

--
Regards, Marten

 

[Marten Hoffmann]

[email protected] schreef ...
> [email protected] schreef ...
> > Can somebody please post the hub dimensions of the Shimano HB-NX70 hub dynamo.
> >
> > Spoke hole diameter? Width to left of centre? Width to right of centre? Left flange diameter?
> > Right flange diameter?
> >
> > I need the dimensions so that I can spokes using Spocalc.xls.
>
> Very often, these hubs have overly wide spoke holes to make lacing them by machine easier. It's
> wise to use small rings under the spoke heads to make them fit snugly.

Of course by "rings" I mean "washers". The correct word didn't come up at the time of writing my
reply. Thanks for the correction, CaptBike aka Sheldon B. ;-)

--
Regards, Marten