I have developed a rather annoying and loud 'ping' which occurs when turning
the bars, I can also feel a vibration through the bars! It's intermitant but
annoying.
I've recently re-adjusted the headset and whilst doing this removed the stem
and applied a little copper grease to the steerer, I put a bit of copper
grease on the top cap bolt too.
Everything went back together correctly and was tightened up to torque using
a torque wrench. I did almost 30 miles on the bike before the ping/vibration
began so it may have nothing to do with this.
I even took the bike into the LBS to get a professional to check the headset
for play and everything seems fine (of course the bike refused to make even
the slightest ping whilst in the shop).
Any ideas? The problem only seems to appear whilst riding, the brake/gear
cable ferruals are greased and there is no obvious source. Was copper grease
on the stem/steel steerer interface a bad idea? I'd assumed the same sort of
cold bonding/rust problems that might occur with a alloy steatpost in a
steel frame, hence the c.grease.
Thanks for any thoughts,
PJay