I have a couple of questions related to my Summit's bearings. I have
searched the forum and come up with some information but I still have
questions.
Question 1. Can I safely remove the bearing shims without doing any
damage? Can I get a different sized bearing that would allow me to
remove the shims?
Question 2. I have trouble getting the bearing cap tightened properly.
Too tight - the bearings are constricted which means the wheel does not
turn freely plus the bearing makes a scraping noise. Too loose - the
shims shift out of place and I get another scraping noise. When I leave
the bolts loose, I am almost afraid they are going to fall out because
they are so loose. The problem here is there is not much difference
between too tight and too loose. I do not have a torque wrench. Does
anyone else out there have problems getting the proper tension on their
Summit bearings? Any ideas? Any suggetions for getting it right?
I have been riding about 16 months and at age 51, I don't ride it real
hard.
--
mucRider - Old Unicycling Newbie
Anything with more than one wheel is too complicated!
------------------------------------------------------------------------
mucRider's Profile: http://www.unicyclist.com/profile/6119
View this thread: http://www.unicyclist.com/thread/34524