Carbon Steerer Expansion Plug Installation?

Bump.

This is a newsgroup, not a forum. "Bump" does not move your msg to the top.

Tim

"Kenny" <[email hidden]> wrote in message
news:[email hidden]...

Quoted message said:

Bump.

Tim McTeague said:

This is a newsgroup, not a forum. "Bump" does not move your msg to the top.

Tim

"Kenny" <[email hidden]> wrote in message

news:[email hidden]...

Quoted message said:

Bump.

It does if your're using your browser and "groups.google.com" to read
the messages.

Kenny said:

Got an Easton all carbon fork. It came with what I think is an
expansion plug that goes into the steerer. The instructions that came
with the fork on how to install this plug isn't clear to me. So my
question is, how do I install it correctly? I have a picture of it
here:

http://bayimg.com/caFnKaABH

Thanks,
Kenny

Screw the bolt in a wee bit, insert into fork steerter and the ridges
of the lower part wiull begin to grip the inside of the
steerer...allowing you to further tighten the top bolt, adjusting the
headset..then secure the bolts on the stem around the fork
steerer..about 5nm is what you are looking for.

Anti-bump