clearing Hydration unit

I normally rinse out and prop open so there is some hope of air flow into
it. Then just leave to dry out. Every now and again clean as recommended in the instructions. I did
end up buying the expensive brush kit and have found it to be worthwhile. I have been using my
bladder 🙂 for a few years now (For about a year it was getting used every week day) and it is
still going strong. No weird green colures or new lifeforms.

I am not sure if it tells you but bicarb is good for occasional cleaning to remove odours.

AJS

"A Yeung" <[email hidden]> wrote in message "]news:[email hidden]...

Quoted message said:

Good day need to know, how to clear and dry the water container of a camelbak unit after use as
planning to buy one.

many thanks Anthony [email hidden]

A Yeung said:

need to know, how to clear and dry the water container of a camelbak unit after use as planning
to buy one.

Follow the instructions. You can read 'em before you buy on Camelbak's site.

Iguana Bwana

Bought a Camelback several years back, drain & flush out the contents after use, then I shove as
much of the hose back into the bag to allow the air to circulate. Once I had some black grime inside
the bak, cleaned it out using a bristle bottle cleaner, no problems since.

I have mine sitting in an office, open to the light.

"A Yeung" <[email hidden]> wrote in message "]news:[email hidden]...

Quoted message said:

Good day need to know, how to clear and dry the water container of a camelbak unit after use as
planning to buy one.

many thanks Anthony [email hidden]

Make sure you only put water in it. it's amazing the life forms that grow in the bladder when you
leave a sports drink for awhile.

A Yeung said:

Good day need to know, how to clear and dry the water container of a camelbak unit after use as
planning to buy one.

many thanks Anthony [email hidden]

A Yeung said:

Good day need to know, how to clear and dry the water container of a camelbak unit after use as
planning to buy one.

I don't have a camelback brand, but I keep the bladder and hose in the freezer between use. Seems to
be ok so far (6 months). I don't use it heaps, but it did seem impossible to get the hose to dry
properly anyway.

-kt

PS> I can also put it in the freezer near-full of water.
It's a 2-litre unit, and has always failed to freeze completely. The best (worst?) I've had was a
5mm crust around the outside of the water, which easily broke up and kept the water cold (but not
freezing) for hours.

One thing I don't like about hydration-packs is when the water in the tube gets warm. If you drink
all the time, then it usually doesn't, but occasionally mine does.

"kingsley" <[email hidden]> wrote in
:"]news:[email hidden]:

<Snip>

Quoted message said:

One thing I don't like about hydration-packs is when the water in the tube gets warm. If you drink
all the time, then it usually doesn't, but occasionally mine does.

You can get bladders with insulated tubes if you think this is a problem, a mate who has one reckons
they work, I am always drinking from mine (North Qld) so not as much a problem (expet whrn
motorcycling, wher eit IS noticeable)

I like the large mouth CB bladders, slip a frozen popper juice in there, cools the water and makes
for a refreshing drink when I stop on the trail for a break.

Trevor S

Trevor S said:

I like the large mouth CB bladders, slip a frozen popper juice in there, cools the water and makes
for a refreshing drink when I stop on the trail for a break.

I've Hydrapaks instead of Camelbaks Trev. An Overflow and a Tracker. The alternative closure
Hydrapak use facilitates the addition of ice cubes just prior to the ride extending the chill time
of the contents. It also facilitates easier thorough cleaning of the bladder itself.

I keep my bladders purely for water, restricting supplemental Gatorade et al to the easier to clean
dual bidons so I never have bacterial growth cleaning or taste residue issues.

Consumption will be close enough to an approx. 1 litre per hour if hydrating as recommended one
should sipping every 10 minutes or so before you're thirsty. At that consumption rate, you'll empty
a 1.5 litre bladder in an hour and a half to two and a half hours in conjunction with alternately
sipping Gatorade from a bidon, less if not. One can do the consumption rate math on a 2 litre.

Chilling the water the night before and adding ice cubes before the ride, the water in the bladder
will remain coolish throughout the ride. Emptying the tube constantly with sips every 10 minutes,
the water in the supply hose will remain sans that horrible mouthful of warmth we've all experienced
when we forget to take a drink for too long in the summer sun's heat.

"OK, so proper planning prevents poor performance, but how about refills in the field smarty pants?"

I'm so well and truly knackered after a 3 hour MTB ride, that's *seldom* an issue for me. 🙂

Iguana Bwana

"The first wealth is health."
- Ralph Waldo Emerson

I have a hydra pak & wash out with clean water after ride then stuff a several scott towel in it
reaching down to the bottom & poking out the top for ventilation so it dries... the hose ! well i
think the only solution is the brush supplied by the makers....which i havnt purchased yet unless
someone has any alternative methods....i have no build up of algae or any other disturbing
growths.....

"Iguana Bwana" <[email hidden]> wrote in message
"]news:[email hidden]...

Quoted message said:

Trevor S said:

I like the large mouth CB bladders, slip a frozen popper juice in there, cools the water and
makes for a refreshing drink when I stop on the trail for a break.

I've Hydrapaks instead of Camelbaks Trev. An Overflow and a Tracker. The alternative closure
Hydrapak use facilitates the addition of ice cubes just prior to the ride extending the chill time
of the contents. It also facilitates easier thorough cleaning of the bladder itself.

I keep my bladders purely for water, restricting supplemental Gatorade et al to the easier to
clean dual bidons so I never have bacterial growth cleaning or taste residue issues.

Consumption will be close enough to an approx. 1 litre per hour if hydrating as recommended one
should sipping every 10 minutes or so before you're thirsty. At that consumption rate, you'll
empty a 1.5 litre bladder in an hour and a half to two and a half hours in conjunction with
alternately sipping Gatorade from a bidon, less if not. One can do the consumption rate math on a
2 litre.

Chilling the water the night before and adding ice cubes before the ride, the water in the bladder
will remain coolish throughout the ride. Emptying the tube constantly with sips every 10 minutes,
the water in the supply hose will remain sans that horrible mouthful of warmth we've all
experienced when we forget to take a drink for too long in the summer sun's heat.

"OK, so proper planning prevents poor performance, but how about refills in the field
smarty pants?"

I'm so well and truly knackered after a 3 hour MTB ride, that's *seldom* an issue for me. 🙂

Iguana Bwana

"The first wealth is health."
- Ralph Waldo Emerson