Shimano OB crank installation?

[=?utf-8?B?4paAU2xhY2s=?=]

Man, I'm confused. I know, what else is new...

I installed my bearings, then fitted the cranks (yes, I did follow
Shimano's instruction sheet), but there isn't much interface between the
the spindle gear shaft and non-drive side crank.
http://www.pbase.com/slack/image/83685940/original

Is this normal. Also, I measured the crank arm clearance between the
cranks and the rear tri:

Drive side Non-Drive
..413" .554"

And I used only one spacer on the non-drive per Shimano's instruction for
a 68mm shell.

What the heck? What I do wrong (shut up JD)? Do I just removel the 2.5mm
spacer?

help... please
--
Slack

 

[=?utf-8?B?4paAU2xhY2s=?=]

On Fri, 10 Aug 2007 20:25:40 -0700, â–€Slack <[email protected]> wrote:

http://forums.mtbr.com/showthread.php?p=3400066&posted=1#post3400066

AMB = 0
Mtb-Retards = 1

No wonder everyone abandoned AMB (shut up JD)
--
Slack