beerco said:In light of this information and assuming your 20 min TT power was measured with a PT, Id say that you probably could have gone a bit better than 218w for your 30k TT. Overcooking the start has a huge impact on TT performance. I'm not talking about the 600w thing which is definitely not a big deal, but the 260 for 3 and 250 for 5 are definitely high if your FT is where I think it is, especially for a 30k TT (what was your time BTW?).
As a somewhat informed guess, I'd say that your FT or 40ktt power is probably around 235 (+/- 10w or so). But, don't take what I guess as gospel. Go out and do some 2x20 intervals and see how you feel. Try and take no more than 5 min between the intervals.
If you can complete the two intervals at around 235 but feel pretty gassed by the end, 235 is a good number. If it's too easy, go out in a couple days and try and hit 245. If 235 is too hard, drop 10w and try again.
I tend to use 2x20 power as a proxy for 40kTT power as 40ks are pretty tough on the body and mind. Doing 2x20s is also excellent training so it's both training and a test. As an alternative, you could always use Ric's MAP protocol which has TT power defined as a %-age of MAP. Sorry Ric, but I prefer the 2x20s because they don't interrupt my training schedule at all.
Correct about the PT.
My time was 50:37. Course was mostly flat, with some short rises that chopped speed down to the 12 mph range here and there (no fun on an aero bike!). I'd cross over 300-330w to get over them, thinking that was a good trade vs. crawling up at 220w.
I took Ric's Test of Suffering Capacity (aka MAP), and came up with 337w. That would estimate my 40TT at 242-259w. Of course, I took the MAP in road position, and then trained/rode the TT in a fairly aggressive, back-almost-flat aero position (reasonably comfy to me). I can't quantify the power loss, but I'd imagine it's material?
Re: intervals above. Are you suggesting that they should be a 40KTT level of exertion, done for 20 mins?