D
Duncan Smith
Guest
Just attempting to swap the forks over on my racer/crosser for some
Kona P2s (1 1/8) threadless (to get the ISO tabs) and I've run into a
bit of a problem...
The forks I'm replacing had an adjuster nut an inch down the steering
tube, however the forks I'm replacing them with have no such nut - so
I can't eliminate the free-play because there's nothing for the cap to
screw into.
I don't have anything long enough to hand, but could the adjuster nut
be popped out with a long screw driver and hammer and popped into the
new forks, or are they typically welded in and I simply have the wrong
forks?
Regards,
Duncan.
Kona P2s (1 1/8) threadless (to get the ISO tabs) and I've run into a
bit of a problem...
The forks I'm replacing had an adjuster nut an inch down the steering
tube, however the forks I'm replacing them with have no such nut - so
I can't eliminate the free-play because there's nothing for the cap to
screw into.
I don't have anything long enough to hand, but could the adjuster nut
be popped out with a long screw driver and hammer and popped into the
new forks, or are they typically welded in and I simply have the wrong
forks?
Regards,
Duncan.