What is the correct way to attach the shifting cable in a Ultegra FD double?
this way?:
http://www.hostelshoppe.com/tech_frontderail.php
"On Shimano bottom pull derailleurs it is important to note that the cable runs UP AND OVER the leverage tab. Many people make the mistake of using the leverage tab as a cable pinch by running the cable UNDER the leverage tab - this changes the pulling leverage of the front shifter and makes it impossible to properly adjust the front derailleur."
OR this way?:
http://techdocs.shimano.com/media/t...001/SI_5JD0A_001_En_v1_m56577569830616200.pdf
But the diagram is unclear to me. Is it running between the leverage tab (or under the leverage tab) and the fixing bolt?
if the manufacturer's info was totally clear I would not be asking...
Thanks in advance
this way?:
http://www.hostelshoppe.com/tech_frontderail.php
"On Shimano bottom pull derailleurs it is important to note that the cable runs UP AND OVER the leverage tab. Many people make the mistake of using the leverage tab as a cable pinch by running the cable UNDER the leverage tab - this changes the pulling leverage of the front shifter and makes it impossible to properly adjust the front derailleur."
OR this way?:
http://techdocs.shimano.com/media/t...001/SI_5JD0A_001_En_v1_m56577569830616200.pdf
But the diagram is unclear to me. Is it running between the leverage tab (or under the leverage tab) and the fixing bolt?
if the manufacturer's info was totally clear I would not be asking...
Thanks in advance