I have acquired a used 3 speed with Shimano 333. I am aware that it may not last too long; that's ok. I still want to rebuild the bike. I also know not to take these things apart.
The hub is basically fine, but:
Does anyone know the correct sequence of the locknuts and washers on the RH (drive) side? There is a washer with an antirotator tab and I am not sure whether it was intended to keep the locknut from rotating the cone or whether it was intended to keep the axle from rotating in the frame. It has a hole with flats corresponding to the shape of the axle. It has one tab. It is a black oxided part.
If you know, please tell me which side of the locknut the thing goes on and which way the tab should face.
The hub is basically fine, but:
Does anyone know the correct sequence of the locknuts and washers on the RH (drive) side? There is a washer with an antirotator tab and I am not sure whether it was intended to keep the locknut from rotating the cone or whether it was intended to keep the axle from rotating in the frame. It has a hole with flats corresponding to the shape of the axle. It has one tab. It is a black oxided part.
If you know, please tell me which side of the locknut the thing goes on and which way the tab should face.