One for the Campagnolo specialists

[Marco Marletta]

I have a set of the very last generation (1997) Campagnolo Athena 8-speed hubs, built into very
light wheels for my summer bike. (Well, very light apart from the 8-speed rear hub, which seems to
have been made by recycling a very shiny boat anchor.)

I also need some new wheels for my winter bike, and there is a deal where I can get them with the
*current* 9-speed Mirage hubs (the ones with cartridge bearings rather than cup and cone).

If I bought these wheels, could I swap bits between the Mirage and Athena hubs to change the Athena
to 9-speed and the Mirage to 8-speed, or have other things changed which make this impossible?

Thanks

Marco

 

[Qui Si Parla Ca]

Marco-<< I have a set of the very last generation (1997) Campagnolo Athena 8-speed hubs, << there is
a deal where I can get them with the *current* 9-speed Mirage hubs (the ones with cartridge bearings

<< If I bought these wheels, could I swap bits between the Mirage and Athena hubs to change the
Athena to 9-speed and the Mirage to 8-speed,

No, the Mirage uses a unique to cart bearing axle and freehub, and will not fit onto the Athena
axle,, which is a cup and cone only.

Peter Chisholm Vecchio's Bicicletteria 1833 Pearl St. Boulder, CO, 80302
(303)440-3535 http://www.vecchios.com "Ruote convenzionali costruite eccezionalmente bene"