B
Bicyclette
Guest
I just installed a suspension fork on my ATB with cantilever center pull brake. The brake cable
housing ends at the top of the headset on a housing terminating bracket tightened under the stem
sitting on the steerer tube. Of course before this was no problem, but now when I yank on the brake
lever with a bit of force the fork moves up due to the suspension.
1) Is that a problem?
2) If it is, is there a cable housing ending bracket that can be mounted to the bridge piece on the
suspension fork itself or is there a different solution?
housing ends at the top of the headset on a housing terminating bracket tightened under the stem
sitting on the steerer tube. Of course before this was no problem, but now when I yank on the brake
lever with a bit of force the fork moves up due to the suspension.
1) Is that a problem?
2) If it is, is there a cable housing ending bracket that can be mounted to the bridge piece on the
suspension fork itself or is there a different solution?